Standard Application Instructions
Application Instructions with Registration Marks (Larger Vinyl Decals
Standard Application Instructions
1. Clean surface thoroughly and allow it to dry completely. (If applying to a vehicle, be sure not to wax the vehicle prior to application).
2. Hold the decal to the surface as is, for proper alignment and placement.
3. Use a piece of masking tape to adhere the decal to the surface. Tape vertically down the center of the decal.
4. On either side of the decal, carefully peel the backing (heavier stock paper) towards the center.
5. Cut away the partial backing.
6. Use a squeegee or credit card to DRAG (not push) from the center toward the outside of the decal to apply the exposed vinyl.
7. Remove the masking tape used for alignment.
8. As you peel the remainder of the backing from the decal, use the credit card or squeegee to DRAG (not push) from the center toward the outside of the decal to apply the exposed viny.
9. Be surea ll areas have been properly burnished with the credit card or squeegee so that all edges have been adhered to the surface and no air pockets remain.
10. Peel the transparent mask off of the surface, leaving behind just your vinyl decal.
11. Do not wash surface for 48 hours after application.
***If air pockets are left behind, carefully poke a small hole using a small needle and push on the air pocket to release the air.
Large Decal Application Instructions
For some decals that are much larger, registration marks are a necessity to line up the elements of the decal appropriately.
1. Clean surface thoroughly and allow it to dry completely. (If applying to a vehicle, be sure not to wax the vehicle prior to application).
2. Hold the decal to the surface as is, for proper alignment and placement.
3. Use a piece of masking tape to adhere the decal to the surface. Tape vertically down the center of the decal.
4. On either side of the decal, carefully peel the backing (heavier stock paper) towards the center.
5. Cut away the partial backing.
6. use a squeegee (or credit card) to DRAG (not push) from the center toward the outside of the decal to apply the exposed vinyl.
7. Remove the masking tape used for alignment.
8. As you peel the remainder of the backing from the decal, use the credit card or squeegee to DRAG (not push) from the center toward the outside of the decal to apply the exposed vinyl.
9. Be sure all areas have been properly burnished with the credit card or squeegee so that all edges have been adhered to the surface and no air pockets remain.
10. Peel the transparent mask off of surface, leaving behind just your vinyl decal.
11. Do not wash surface for 48 hours after application.
***If air pockets are left behind, carefully poke a small hole using a small needle and push on the air pocket to release the air.
***Use the round registration marks to line up the pieces of the decal. Do not burnish them to the wall too hard and they can easily be removed with the entire decal is in place.